| Rans S-9 and S-10 discussion group
|
[
Rans S-9 and S-10 discussion group ] [ FAQ ] |
|
[Previous Message]
[Next Message]
|
|
Date: May 12, 2008 at 02:18:21
From: Frans, [d54c50e57.access.telenet.be]
Subject: Re: Rotax 582 exhaust |
|
|
Hi Karl, I recently finished the exhaust installation on my S9. At first sight, I could not make the straight rotax pipe with the standard 90 degree elbow fit. To be honest, I must tell that I failed to observe the correct orientation of the "Y" manifold..!
This manifold should be pointing upwards. (as per instructions in the Rans assembly manual.)
I never came that far, since I in the meantime decided to fabricate my own 90° bend. So I can use the "Y" manifold facing down, and that brings the entire straigt rotax exhaust nicely in line with the fuselage. Note that the straight manifold needs to be altered a bit for this installation, this in order to make it fit and "to stay in tune". So Karl, that still leaves you with your question unanswered, but I told you my story since I believe this would offer a good solution if you stil would have problems making the standard straight rotax exhaust fit your fuselage...
Best regards,
Frans.
|
|
|
| View the previous message in this thread
Go to the top of this thread
View entire thread |
[Previous Message]
[Next Message]
|
|
|
Follow Ups: |
|
|
[
Rans S-9 and S-10 discussion group ] [ FAQ ] |
|
| TalkShop 2.76 |